This could result in the corner getting a radius when the part is intended to possess a razor-sharp angle. If the position between the two outlines is higher than the inside corner angle no exclusive tool route is included to the intérsection of the twó ranges. If the angle between two outlines in a personality or DXF file is less than the inside corner angle F-Engrave will make a device path most the way to the intérsection of the twó ranges creating a sharpened corner. I need to add some structure pics of what is heading on with these configurations) Transforming the inside and outdoors corner position will alter the angle at which F-Engrave detects a sharp corner. I have not really needed to alter them from the current defaults) The choices are challenging to describe but I will give it a chance.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |